通過式清洗機是標準化批量生產的，在使用中若出現故障無法使用時，很大一部分原因是保險絲燒了，這也是很多使用者遇到過的多的故障之一。

The through type cleaner is produced in a standardized batch. In case of any failure in use, most of the reasons are fuse burning, which is one of the many failures that many users have encountered.

原來使用正常，如遇到開機后沒有動作，則要檢查有沒有電源顯示，如果沒有，首先要檢查的就是電源座內的保險絲是否損壞。從電源座拔出保險絲，查看有無斷裂的的情況。

It used to work normally. If there is no action after startup, check whether there is a power display. If not, first check whether the fuse in the power socket is damaged. Pull out the fuse from the power supply base and check for any breakage.

機器長時間運行或操作不當引起電源線短路都可引起保險絲燒壞，這樣的情況下用戶只需自己更換保險絲即可。

The fuse can be burnt out due to the short circuit of the power line caused by the long operation or improper operation of the machine. In this case, users only need to replace the fuse themselves.

還有一種有可能是用戶接地線與火線或零線混用，并沒有接地。因為本機地線是與機器外殼相連接，或者可能是機器短路，元器件的老化引發的短路現象，導致保險的損壞。

Another possibility is that the user's grounding wire is mixed with the live wire or neutral wire, and there is no grounding. Because the grounding wire of the machine is connected to the machine shell, or it may be the short circuit caused by the aging of the machine and components, which may lead to the damage of the insurance.

檢測方法：

Test method:

取出保險絲觀察，有無斷裂情況，用萬用表通斷檔測量有無斷開，判定是否需要更換新器件。

Take out the fuse and observe whether it is broken. Use a multimeter to open and close the gear to measure whether it is broken, and determine whether it is necessary to replace a new component.

另外在使用通過式清洗機時應注意的問題：

In addition, pay attention to the following issues when using the through type cleaner:

1.嚴防線路短路：設備的清洗槽是采用304不銹鋼一次沖壓成型的，排水口也都做了有效的防水處理。但是在使用時，必須特別注意保持干燥以防線路短路。

1. Strict prevention of short circuit: the cleaning tank of the equipment is made of 304 stainless steel by one time stamping, and the drainage outlets are effectively waterproof. However, during use, special attention must be paid to keeping it dry to prevent short circuit.

2.運行時間不宜過長：通過式清洗機不適合長時間運行，一般運行超過一個半小時必須休息，以確保溫度不會過高，清洗槽中必須加入清洗液后才能啟動。

2. The running time should not be too long: the through type cleaner is not suitable for running for a long time. Generally, it must have a rest after running for more than one and a half hours to ensure that the temperature is not too high. The cleaning tank must be filled with detergent before starting.

根據清洗任務，如果需要長時間批量進行工作的清洗作業，則可以選擇定制我們這里的清洗機m.chendakeji.cn，為你提供滿意的服務！

According to the cleaning task, if you need to work in batches for a long time, you can choose to customize our cleaning machine m.chendakeji.cn to provide you with satisfactory service!